Sometimes an ethernet adapter on your motherboard will populate a COM port, which will confuse the script and it will attempt to flash to that COM. If it fails to flash (may display a success message but has errors show up above the final success output), check if it is flashing the correct COM.Plug in a battery or otherwise power up the RX. ![]() Hold the boot button of the RX or jump the boot jumper.If your RX gets powered from USB, desolder the power wire so that you can manually power it up independently of the flight controller. Plug in your FC to your computer, but do NOT connect to betaflight configurator and no NOT power the RX.If it still doesn't work, the bootloader might be messed up and the following steps should work. If you're unable to get it to work, your firmware might be corrupted, in which case you'll need to temporarily turn off the telemetry feature in betaflight. Since 1.0.0, ESP receivers can be updated via passthrough without using the boot button as long as the firmware is not corrupted. Select env:YOUR_RX_via_Betaflight_Passthrough and hit upload.Plug in your FC to your computer, but do NOT connect to betaflight configurator. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |